DALI gateway Plus for KNX

Features

• Compatible with DALI and DALI-2 Standard.
• The DALI gateway Plus forms the interface between a KNX installation and a digital DALI lighting system.
• Control of max. 64 DALI operating devices as individual control, group control in max. 32 groups, or central control via a broadcast telegram (group 17 – 32 each with max. 2 operating devices).
• Manual operation of the devices also independent of the bus (also building site operation with broadcast control).
• Energy-saving function: Deactivation of the power supply to the DALI operating devices possible in a switched-off state (using additional switching actuator for KNX).
• 16 light scenes.
• The groups can be integrated in the light scenes.
• Effect control can be configured for max. 16 sequences in 1 to 500 run-throughs (or infinite).
• Feedback about DALI error status or short circuit and notification of power supply failure.
• Active or passive (object can be read out) cyclical feedback function.
• Group feedback of all switching conditions possible.
• Feedback can be delayed until after the recovery of bus voltage.

Group and device functions

• Switching and brightness value: Active (send to the bus in case of change or cyclically) or passive (object can be read out) feedback functions.
• Brightness range can be set.
• Bulb-saving switch-on and switch-off
• Dimming behaviour can be parameterised.
• Time functions (switch-on or switch-off delay, advanced staircase function – pre-warning function in accordance with DIN 18015-2 or reduced continuous lighting).
• Block function or alternatively forced setting function can be parameterised for each group. With block function, the flashing of light groups is possible.
• Readout of the DALI device status using KNX.
• Elapsed-hours meter as forward and backward counter with limit value evaluation.
• Online or offline configuration of the DALI devices using ETS plug-in.
• Replacement of an individual, defective DALI device is possible during operation without ETS.

Operation of emergency lighting

• Suitable for operation in emergency lighting systems.
• Control and monitoring of individual-battery and centrally-supplied DALI emergency lighting systems.
• Support for DALI emergency light converters in accordance with EN 62386-202 (individual battery-operated emergency lights with DALI interface): Function test, continuous operation test, limited continuous operation test, query of the battery charge.

Technical data

Notes

• DALI-2 support from index level I06.
• Operation of emergency lighting systems:The legal and normative requirements vary from country to country. In any case, the user / professional planner should ensure that the specific guidelines are observed.
• VDE approval in accordance with EN 60669-1, EN 60669-2-1.
• Configuration and start-up of the device from ETS 4.1 (recommended) or with ETS 3 using version “d” or higher.

Scope of supply

• Connection and junction terminal for KNX included with delivery.

Dimensions

Additional figures available in the media database

Further links