eNet wireless switching or momentary-contact actuator, 1-gang

Item comparison | 1

Cancel comparison selection

Media database

Not currently available to order. Expected to be available again from October 2023.

Necessary accessories

One of the following articles:

server DRA WL receiver mod. DRA

Features

The eNet wireless switching or wireless momentary-contact actuator receives telegrams for switching lighting from the eNet wireless reception module or eNet server via a data cable.
Operating modes: Switching actuator or momentary-contact actuator.
Status feedback to eNet wireless transmitter.
Scene operation.
Operating mode buttons: Relay contact stays closed as long as telegrams are being received (max. 60 seconds).

Can be set with eNet server:

Flashing function.
Delay time.
Switch-on/off delay.
Switch-off pre-warning.
Minimum switching repeat time.
Permanent-on, permanent-off.

Technical data

Rated voltage:

AC 230 V, 50/60 Hz

Standby:

max. 0.2 W

Ambient temperature:

-5 °C to +45 °C

Switching capacity AC 230 V:

16 A / AC1

Connected load

Light bulbs:

2300 W

HV halogen lamps:

2000 W

Wound transformer:

1000 VA

Tronic transformer:

1500 W

Fluorescent lamps, uncompensated:

920 VA

LED lamps:

typ. 500 W

Compact fluorescent lamp:

typ. 500 W

Capacitive load:

690 VA (560 µF)

Connections:

max. 4 mm²

Length of the data cable:

Max. 3 m

Notes

An eNet wireless reception module or an eNet server is required to operate this DIN-rail mounting device.

Dimensions

Modular widths (MW):

Additional figures available in the media database

You will find figures of the selected products in the media database. You may use this figures for your publications. Please read the corresponding terms of use.

To the media database